Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Ammunition & Reloading (http://www.firearmstalk.com/forums/f30/)
-   -   AR 15 brass question (http://www.firearmstalk.com/forums/f30/ar-15-brass-question-9465/)

tbone8705 12-28-2008 02:06 AM

AR 15 brass question
 
I have been reloading for many years, and I am building my first AR 15. I reload for myself in 264 mag, 270 and 7mm Mag. I only neck size my brass for these rifles to cut down on brass stress, and was wondering if 223 brass needs to be full length resized after firing, or will just doing a neck size work since they will only be used in the same rifle. Thanks for any info you pros can give me

cpttango30 12-28-2008 09:16 PM

In the AR rifle I think you need to full length size it everytime and use small base dies as well. I am not 100% on this as I don't load 223 for an AR......

ronl 12-30-2008 11:15 AM

Definitely full length size any and all brass intended for semi-auto use. Unless you have a match chamber I see no need to go to the small base dies. I use standard FL RCBS dies in reloading for my AR and have never had a problem.

robocop10mm 12-30-2008 02:38 PM

Depending on the dimensions of your chamber, full length sizing will likely be appropriate. Some prefer small base to insure feeding reliability under adverse conditions.
Remember to trim your brass, especially if using 5.56 bases a they tend to start off a little long and will stretch with firing/resizing. I have seen a gun blown because of untrimmed cases and a slightly (.3 grains) over charged powder payload.


All times are GMT. The time now is 12:28 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.