Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Ammunition & Reloading (http://www.firearmstalk.com/forums/f30/)
-   -   9mm handloads for rifle (http://www.firearmstalk.com/forums/f30/9mm-handloads-rifle-47080/)

redscho 08-19-2011 07:18 PM

9mm handloads for rifle
 
Looking for load data for 9mm Luger to be used in Kel-Tec Sub2000 carbine or similar rifle with 16-18 inch barrel.

orangello 08-19-2011 07:23 PM

Just here to learn.

robocop10mm 08-19-2011 08:09 PM

You can use any moderate to high vel load listed for the handguns. I would avoid really low power, starting loads to hopefully avoid sticking a bullet in the barrel. Higher end loads using slower powders may give better results.

JonM 08-19-2011 10:46 PM

Quote:

Originally Posted by robocop10mm (Post 566200)
You can use any moderate to high vel load listed for the handguns. I would avoid really low power, starting loads to hopefully avoid sticking a bullet in the barrel. Higher end loads using slower powders may give better results.

+1

your going to get better performance just due purely to the longer barrel with standard loadings. hopefully your not thinking about hunting with it. even from a rifle the 9mm is barely sufficient for rabbit hunting.

Glasshartt 08-19-2011 10:47 PM

Everything I have seen really stresses no aluminum cased ammo

Lindenwood 08-20-2011 01:07 AM

Quote:

Originally Posted by JonM (Post 566269)
+1

your going to get better performance just due purely to the longer barrel with standard loadings. hopefully your not thinking about hunting with it. even from a rifle the 9mm is barely sufficient for rabbit hunting.

If people successfully hunt with a 4" .357 revolver, one can hunt with a 9mm from a rifle, ESPECIALLY if handloading. There are factory loads that push a 125gr bullet to 1400fps out of a carbine, and they are still tayored for a pistol. Experimenting with powders that are a bit slower by one or two steps could increase the velocities even more. I wouldn't doubt one could get a 147gr bullet going at a good 1200fps or more with some fiddling.

I'm not saying they should be taking on 300lb game, because I know the .357 is still overall more capable but a 120lb deer isn't going to tell the difference between a .355 125gr bullet at 1400fps, and a .357 125gr bullet at 1400fps. Hell, I remember one guy took a deer with his 9mm carbine and the round went through both shoulder blades and stopped in the hide on the other side.

And I'd imagine any load within standard range designed to cycle an auto won't give you any trouble as far as the bullet getting stuck in the barrel. Turning it into a quiet "bolt-action" is where you might get into trouble, though I'd still see no point in loading light if you are wanting the velocity increase from a carbine.


All times are GMT. The time now is 08:59 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.