Firearm & Gun Forum -

Firearm & Gun Forum - (
-   General Shotgun Discussion (
-   -   Question about buying a used shotgun (

JoeCool 04-10-2009 08:54 PM

Question about buying a used shotgun
I have minimal experience buying used guns, and am hoping there are some folks on here that can offer me some advice and suggestions on a potential purchase.

The shotgun in question is a Maverick Model 88 with a black finish.

I am about to head out the range to make sure it functions properly, but the question I have is in regards to the cosmetics. It has small spots of very superficial rust in many places. How big of a deal is this? If I buy it is there a way to clean it off without refinishing it?

Does anyone have any experience with this brand?

Thanks for any info you can provide.


c3shooter 04-10-2009 09:25 PM

IF the shotgun in question was a Merkel, Purdy, Holland & Holland- YES- it WOULD be a big deal. But those are collector guns worth more than my HOUSE!

For light surface rust, wet down good with a decent gun oil (Remoil works) let soak, and rub with a soft, clean cotton cloth. You can get more aggressive with 0000 steel or brass wool, and light oil. A really stubborn spot of rust- find an older COPPER penny (new ones are copper plated zinc) and use the edge of the penny to scrub LIGHTLY. Follow up with oil/cloth.

For times you need a penetrating oil, 50/50 mix of acetone and ATF (automatic transmission fluid) apply, let set, buff with cloth. Careful- is flammable.

There is also a polish called FLITZ that can be used on light rust without screwing up the blue. But remember bluing is a thin layer of black iron oxide- anything used too enthusiastically will buff away that thin layer.

R-BOLT 04-10-2009 09:31 PM

I will guess you will get better suggestions than this, but this is what I have done with my guns in the past, has worked pretty good.
1st try light gun oil and a rag, might clean it up good enough.
2nd light gun oil and rub lightly with wadded up tin foil.
3rd light gun oil and rub lightly with fine steel wool or 3M cloth, do not rub to hard or long as you will wear thru the blueing. Happens fast!! I know!

JoeCool 04-11-2009 12:18 AM

Thanks for the helpful info. I will buy it and clean it up.

With money being so tight and firearms getting more expensive I am glad to hear that it's okay to buy it.

Thanks again.


robocop10mm 04-13-2009 12:56 PM

+1 on the 0000 steel wool. Use it very wet. The rust you are removing is more abrasive than the wool so keeping it flushed away is very important. I use gun solvent to wet the wool. For stubborn small spots, try a pencil. The point of graphite can remove and displace the rust in small pits.

Minionsram 04-15-2009 03:29 AM


Originally Posted by JoeCool (Post 93214)

Does anyone have any experience with this brand?


Yes I bought one for the wife and see loves it. It is a good firearm that will not set your wallett on fire. Here is hers:)

All times are GMT. The time now is 06:37 PM.

Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.