Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   General Shotgun Discussion (http://www.firearmstalk.com/forums/f26/)
-   -   Old Reming 870 Wingmaster Barrel Question (http://www.firearmstalk.com/forums/f26/old-reming-870-wingmaster-barrel-question-78278/)

Ro-bang 12-12-2012 06:38 AM

Old Reming 870 Wingmaster Barrel Question
 
Hey all, first time poster and I have a question about my Remington 870 Wingmaster. It's a slightly older model, I think it was made some time around the late 70s early 80s. I love the thing but I want to remove the 30 inch barrel and replace it with a 18-20 inch barrel. I've heard that newer Wingmaster barrels are built to different specs, and won't fit. I don't think this would be true, but I figure it'd be better to ask before going through with any purchases. Thanks for reading.

scottybaccus 12-12-2012 08:26 AM

There are aftermarket barrels available for early and late models. I have a late model police gun that I use a early model bird barrel on, also. The only difference I see is the detent ball that retains the magazine tube retaining nut. Early didn't have it. Late model does.

I suggest you identify the barrel you want, then call the manufacturer (you aren't limited to Remy barrels) with the part number and tell them your application. They will give you a firm answer.

Virginian 12-12-2012 10:55 AM

I think you got that backwards. The early models did have the detent in the magazine ring, and the newer ones use the "green monster" saw toothed plastic thing inside the mag tube. A 3/32" 'O' ring will hold the mag cap on just fine. All the barrels will fit. If you have a 2-3/4" receiver gun, 3" hulls may not eject properly even if fired from a 3" chambered barrel. Ejector is different.

bobski 12-12-2012 08:47 PM

the eject port isnt as big either on the 2 3/4".

Virginian 12-13-2012 12:13 AM

The receivers on the older 2-3/4" guns and the 3" Magnum guns are identical. The ejection port is the exact same size. The ejector and ejector spring are different. I have converted several. Some 2-3/4" guns made it out the door with a 3" ejector/ejector spring set up, so check. You may get lucky.

John_Deer 12-16-2012 03:30 AM

If you have a regular gunsmith he should order the proper barrel for you. I got my 28" rem choke barrel from Buds Gun Shop. Once you identify the barrel you want shop it out. Prices vary from vendor to vendor. Since you want a security barrel an aftermarket barrel might serve you just as well if not better. Aftermarket barrels are less expensive.


All times are GMT. The time now is 01:01 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.