Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   General Shotgun Discussion (http://www.firearmstalk.com/forums/f26/)
-   -   20GA HD Gun (http://www.firearmstalk.com/forums/f26/20ga-hd-gun-2460/)

EHCRain10 10-26-2007 03:52 AM

20GA HD Gun
 
have a spare 20ga Mossberg 500 that i would like to turn into a HD gun.

I would like to simply replace the current 26in Vent Rib barrel with a new one in the 18-22 inch range that has either ghost ring or rifle sights already installed.

I have been searching off and on for about 2 months now and havent found a barrel that fits what im looking for.


My question is should i just buy a new barrel w/o a vent rib to replace the current one or can the vent rib be removed from the current barrel at the same time that it is being shortened? and how much would be a reasonable price to shorten a barrel and retap it for choke tubes?

Bidah 10-26-2007 07:29 AM

I do not believe that you will find a HD length barrel for a 20ga. You will have to either cut the one that you have now, or find one that is close to what you want and then have that one cut. I don't know what it would cost, but it should be too much. The most expensive part is the choking.

-Bidah

WMW0505 11-06-2007 02:02 AM

I don't know about the Mossy part, but Remington offers a 20 ga HD gun with an 18" barrel. I'm sure you could find a 18" barrel if you look in the right place.


http://www.rrarms.com/catalog.php?prod=G50452

EHCRain10 11-06-2007 03:40 AM

how hard would it be to either pull the vent rib off or have a gunsmith remove it?
would the barrel have to be refinished if the vent rib was to be removed?
being that its a HD gun and wouldnt be used past 35 feet i dont think a choke is really needed.


All times are GMT. The time now is 08:19 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.