Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   .22 Rifle/Rimfire Discussion (http://www.firearmstalk.com/forums/f21/)
-   -   Hogue overmolded stock for Ruger 10/22 (http://www.firearmstalk.com/forums/f21/hogue-overmolded-stock-ruger-10-22-a-7509/)

Ram Rod 10-09-2008 11:43 AM

Hogue overmolded stock for Ruger 10/22
 
Here is what I normally go outside with. It's the one the wife likes to shoot best. I have the Hogue overmolded stock and the Butler Creek carbon fiber barrel. The whole rifle goes about 4lbs. Too light for me to use in silhouette for sure. The texture is just like the Hogue grips with a pebble finish molded around a basic fiberglass stock. My recommendation........get it! This past spring, we started having some failures of the ten round 10/22 mags ejecting from the gun....turns out it was the stock opening actually, and the fact that the Ruger factory mags are not uniform front to back in measurements. Here's a pic of the rifle stock, and my cure for the mag problems:
This image shows the 'hang-up' at the rear of the magazine opening in the stock
http://i132.photobucket.com/albums/q...g/ammo2010.jpg
Here is what I found on the Ruger factory magazine measurements
http://i132.photobucket.com/albums/q...g/ammo2012.jpg
http://i132.photobucket.com/albums/q...g/ammo2013.jpg
And the cure with the help of the Dremel
http://i132.photobucket.com/albums/q...g/ammo2016.jpg


All times are GMT. The time now is 07:19 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.