Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   AR-15 Discussion (http://www.firearmstalk.com/forums/f20/)
-   -   scope mounting (http://www.firearmstalk.com/forums/f20/scope-mounting-48464/)

newbie 09-18-2011 10:32 PM

scope mounting
 
is there a big difference in a2 scope mounting between a a3 or a4 rail

JonM 09-18-2011 11:23 PM

depends on if your mainly going to use it with a scope or open sights. i shoot 90% of the time open sights on my AR. i have the fixed handle A2 and have yet to find a good mount for it.

if most of your shooting is scoped get a flattop or an EOP topped reciever

mjkeat 09-18-2011 11:25 PM

Yes, cheek weld and when looking at some of the higher end picitiny mounts I'd assume the pic mounts are much more reliable/rugged.

kenhesr 09-19-2011 04:00 AM

Yep there sure is! Due to "old eyes" (had the same two all my life :rolleyes:) - I use scopes on most of my AR's.

I have a couple of A2's but the last 20 or so that I've built have been A3's.

Like mjkeat pointed out you can set your cheek weld perfect for your head and its easy to do a rock solid mount on an A3.

Now this is just what I do, not saying its right for you, but I use a standard FSB on all my A3 uppers. I also use a removable rear sight, (Bug-Out Handle). They are only around 50 bucks, not much $$.

My scopes are mounted with a quick release riser or rings. Before sighting in the scope, I sight in the iron sights, pop them off, now I have back-up irons for each rifle. Sight in the scope, then I can switch back and forth between A2 type sights and a scope with no loss of zero on either.

JonM is telling it true, its a real sob trying to get a good solid mount on an A2.

http://i106.photobucket.com/albums/m...weapons014.jpg

The AR in the pic is the one I carry in my vehicle. Its an A3 with a removable bug-out handle, if you look close you can see the two bolt knobs that hold it on. I have a couple with just a removable fold down rear sight, but I like the full handle better, guess its all in what you are more comfortable with.

Good luck with your project & welcome to the forum, Ken


All times are GMT. The time now is 05:53 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.