Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   AR-15 Discussion (http://www.firearmstalk.com/forums/f20/)
-   -   Red dot Sighting (http://www.firearmstalk.com/forums/f20/red-dot-sighting-54401/)

synical 12-30-2011 03:37 PM

Red dot Sighting
 
I have a Nc Star 3-9x scope on my AR and on top it has a red dot but I cant seem to get the red dot sighted. It is either too high or shooting the dirt for somereason I cant get it to go down range is there a way to do it other than getting a bore sight?

purehavoc 12-30-2011 03:53 PM

Sounds like you got a bad red dot , Send it back and try again , NCS isnt know for the best quality

Sniper03 12-30-2011 03:59 PM

Synical,

If the mount is tight and the impact point is changing that much with the rifle sand bagged and benched. As Havoc stated you certainly have a defective sight. I would contact the manufacturer and advise them. If it is new they should repair or replace it at no cost. If used, they might charge you a few bucks to repair it! *But for no more than the unit costs I would get an estimate from them when you send it in before I authorized the start of the repair.

03

synical 12-30-2011 04:21 PM

ok sounds like a plan!

synical 12-30-2011 08:53 PM

actually I went today and got a laser bore sight just to make sure I am doing everything right! I am gonna try that before I send anything back.

Quentin 12-30-2011 08:55 PM

Do your scope and/or irons hold zero? If so, they're much better than a bore sight. (Of course none of them would help much if you have a loose or defective RDS).

AgentTikki 12-30-2011 10:26 PM

There are parallax issues for RDS. Try and boresight it as far as possible. 15 yards should be good enough.

mjkeat 12-30-2011 10:36 PM

I'd also look at mounting your RDS at 45 degrees off the rail on your upper receiver.

synical 12-31-2011 02:59 PM

1 Attachment(s)
well I cant really remount it its on top of my scope see what I mean!

Quentin 12-31-2011 03:01 PM

That gun is getting pretty busy! :D


All times are GMT. The time now is 10:32 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.