Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   AR-15 Discussion (http://www.firearmstalk.com/forums/f20/)
-   -   Mid-length/carbine length conversion (http://www.firearmstalk.com/forums/f20/mid-length-carbine-length-conversion-19883/)

AKCoastie89 11-08-2009 08:49 PM

Mid-length/carbine length conversion
 
Would it be possible to replace the standard front iron sight on an AR upper with a flat rail for flip sights? Additionally, if that were possible, would it be possible to move the front sight/ end cap back to covert a mid-length hand guard to a carbine-length?

Dillinger 11-08-2009 08:55 PM

Yes. And Yes.

However, changing the gas bleed location really should be done by an experienced professional.

However, there are parts like what you are looking for at Yankee Hill Machine, LaRue tactical and a few other specialized AR outfits.

slowryde45 11-08-2009 11:31 PM

Yes, but why? :confused:

Do you just want the shorter length handguards of a carbine? The mid-length gas system will give you smoother recoil impulse over a carbine, less wear/tear on your system, longer sight radius - all good things. If you are just trying to change out an A2 front sight, no problem. You can remove and replace it with quite a few different front gas blocks, with or without rails, some even with flip down front sights.

Check out these links for a few different options:

AR-15, M16, M4, Front Sight Bases

PK Firearms | Online Store

Rainier Arms, LLC™ | Manufacturer

YHM, Yankee Hill Machine Co., Inc. – Makers of High Quality Firearms, Accessories & Sound Suppressors | Sights

The longer forearm of the mid-length also allows you to extend your grip out farther on the forearm, which leads to more accurate target transition/acquistion on the move. Of course that is just my .02 :rolleyes:

I guess I'm just a little confused as to what you are trying to achieve going this way. But hopefully the above links help you out. It wouldn't be too hard to change out the front sight and go to a railed gas block or one that has a front flip down sight built in. But if you leave the gas block where it's at, then change to carbine length hand guards, I think it's going to look a bit odd, to say the least. If you are trying to totally convert it to carbine length, you'd have to weld/seal the gas hole, relocate and re-drill a new hole, in the correct location for carbine length gas impulse. It would be easier to just buy a new carbine length upper or barrel assembly, most likely cheaper than paying shop prices to do the modification. Again, just my .02.

Slo


All times are GMT. The time now is 12:02 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.