Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   AR-15 Discussion (http://www.firearmstalk.com/forums/f20/)
-   -   ar15 problems (http://www.firearmstalk.com/forums/f20/ar15-problems-37580/)

edteach 01-29-2011 01:37 AM

ar15 problems
 
I have two ARs. One is a PWA and the other a factory colt. I just put on two sets of KNS anti walk anti rotate pins. In the PWA they seem to work fine. but I put the other set in the Colt and noticed that when I charged the bolt back it would lock up going forward. I had to pull the trigger and at the same time pull the bolt back and then release it with trigger pulled to get it to go into battery. I removed the pins and put back in the old set and the bolt worked fine again. The Colt is a 96 made with 800 rounds through it. I think the pins are a bit small for the colt and allow the hammer to rise just a bit to lock up the bolt. I put them in exactly like instructed with the anti rotate pin going into the hammer [the pin with ears]

The other problem I have is that I have four mags 20 rounds each a colt mag that over strips rounds on three mags. All of the problem mags are all plastic followers and all the mags are colt. The two with aluminum followers seem to work OK. Has anyone had this problem and is there a fix? The mags are good except for this. Is there a stronger spring that can make them work ok? Or maybe new followers?

Quentin 01-29-2011 04:35 AM

Sounds like you have a large pin Colt so the standard pins won't work. Fortunately you really don't need the KNS pins so it's not anything to worry about. I suppose you could check and see if they make a set for the older Colts.

I have a couple Colt 20rd mags with plastic followers that work reliably so can only say that yours should work. Don't know what to say other than try more magazines if you have access to them. Maybe it's time to replace the magazines with PMAGs or standard GI.

edteach 01-29-2011 04:39 AM

Quote:

Originally Posted by Quentin (Post 432026)
Sounds like you have a large pin Colt so the standard pins won't work. Fortunately you really don't need the KNS pins so it's not anything to worry about. I suppose you could check and see if they make a set for the older Colts.

I have a couple Colt 20rd mags with plastic followers that work reliably so can only say that yours should work. Don't know what to say other than try more magazines if you have access to them.

I think your right. The pins are noticeably larger than the ones that came out of my PAC west rec. The dif. must be enough to allow the hammer to move and lock up the bolt. I ordered the correct ones. I really like the no rotate and move system. I have also ordered the SS no tilt followers. They were only 3 each from Midway. I will give them a try.

USEBOTHHANDS 01-30-2011 03:42 AM

definitely wrong pin size(s), if the SS followers start giving you problems, try the anti-tilt P-Mag followers.


All times are GMT. The time now is 12:05 AM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.