Here's the one I purchased: I also bought the rubber butt pad, went on perfectly. The stock completely corrected the length of pull issue I have with AKs. Removing the stock that came with the WASR 10/63 involved removing two screws then leveraging a large screw driver into the receiver and pushing it off.
I did not use the little tiny screws supplied by Tapco, but instead drilled starter holes, with the supplied bit from Tapco and used the much longer/stronger original screws, had to use a power drill with a phillips head bit to get the necessary torque to get the screw countersunk, the front most one particularly, so that the spring and guide rod would go back into their original position.
Here's a picture:
__________________ Member of: NRA (Life); GOA (Life); NSSF; GCA.
Guns and Shooting Videos: VDMA Videos.