Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   General Rifle Discussion (http://www.firearmstalk.com/forums/f18/)
-   -   Winchester 94 & Uncle Mike's sling mounts (http://www.firearmstalk.com/forums/f18/winchester-94-uncle-mikes-sling-mounts-48704/)

Scratchammo 09-23-2011 11:58 PM

Winchester 94 & Uncle Mike's sling mounts
 
It's obvious how to set it up but I'm curious about the drilling part. How far from the butt should I drill for the screw & what size bit should I use?

jpattersonnh 09-24-2011 12:02 AM

Measure the screw, use a bit a size or 2 smaller. Just a hair shorter then the screw for depth. About 1/2 to 2/3rds from the action will work fine.

Snakedriver 09-24-2011 12:24 AM

1 Attachment(s)
It's really pretty easy and the Uncle Mikes come with detailed instructions that includes bit sizes for the pilot holes. It's actually a two-step process. Here's how I do it:

1. Put a piece of blue painters tape or masking tape over the spot where you want to mount the swivel stud. Mark the spot with "X" and center punch it or use a nail. I placed mine about 2" from the end of the buttplate.

2. Drill the bigger pilot hole first to about 1/8" deep.

3. Drill the second smaller pilot hole in the center of of the bigger hole to a depth of about 5/16" deep. Remove the protective tape.

4. Put the white spacer washer on the sling stud and screw the stud into the pilot hole until it is tightly seated in the bottom of the bigger pilot holt.

5. Attach the sling swivel to the stud and you're done. :cool:

hiwall 09-24-2011 12:46 AM

If I remember, the bit sizes are 5/32" and 7/32". Drill 2 to 3 inches from butt. Make sure you drill perpendicular to the stock. Pretty simple job.


All times are GMT. The time now is 03:59 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.