[SoL]

you bet, my man.

I might actually post some pictures of my design sketches and blueprints.
I'm fairly sure it's physically viable but would appreciate input if anyone can see any potential problems.

[SoL]

i've attached a paintshop recreation of my design.

I did it with a grid so its accurate to my 1:1 scale blueprint.

I wanted to keep it very simple with a lot of flat faces and right angles, short of the grip and cheek pad.

most of the shooting that rifle does is supported, by a car door or a fence post usually so I thought it prudent to have a large flat undersurface to rest on, I will have rubber stripping protecting the majority of the frontend underside from dings, but i'm sure it will be a good thing in all.

I also made the stock quite a bit longer than the original, I prefer it this way is all, personal opinion.

That pistol grip is modelled on a hogue ar 15 one, so its finger grooves should be quite nice.

Any obvious flaws ive overlooked?

[SoL]

what in the living land of cockskull is this?

[CA357]

Troll, spammer or just a whack job. Sometimes they get through. He'll be gone soon.

[SoL]

hehhehheh, fun.