Firearm & Gun Forum -

Firearm & Gun Forum - (
-   General Rifle Discussion (
-   -   Speer vs Hornady Soft Points - Differences? (

Joshua M. Smith 12-27-2011 11:45 AM

Speer vs Hornady Soft Points - Differences?

I'm an Indiana boy and, as such, don't know much about rifles.

I use them to plink and knock over coyotes. Growing up we had to use slugs or handguns for deer, though we can now use handgun-round-chambered rifles for them.

Anyway, when I want to knock over coyotes, I usually just grab something soft-point. Seems to do the job just fine.

Recently I grabbed a couple partial boxes of Hornady and Speer soft points off of Gunbroker for not a lot.

They both load shoot nicely with 45 grains Varget from a 7.62x54R. COAL is about 2.90" with the bullets caliber deep.

My question is, what's the difference? The Speer says on the box "spitzer soft point" and the Hornady appear to be interlocks.

Both are 150 grains or thereabouts.

What are the differences between these two bullets? Just cosmetic?



cottontop 12-27-2011 02:14 PM

There is not a whole lot of difference. In some rifles I have had, the Speer was more accurate, in others, the Hornady was more accurate. That just depends on what each particular rifle likes. Most Hornady game bullets have a cannulure (sp?) where Speers do not. That may make a difference if you want to crimp the bullet. Both of them perform well on game.

jeepejeep 12-27-2011 02:29 PM

Yeah, what cottontop said. In my 30'06, the Hornady's are a bit more accurate than any others I've tried so they get the nod. Other guns I load for aren't very particular so I use whatever I can find in the bullet style I'm looking for for the least money.

Oohrah 12-27-2011 10:15 PM

Go with the most accurate! Ya can't kill what you don't hit in a vital area!!!

locutus 12-27-2011 11:37 PM

In my rifles, the Speer is a trifle more accurate. But the difference is small.

I shoot five 10 shot groups at 200 yards for accuracy.

Generally in my heavy barrel .308, the Speers will average 1.8 to 2.1 iches, and the Hornadys 2.1 to 2.4. (Remember, these are an average of 5 ten shot groups at 200 yards)

That isn't enough difference to matter in a .30 calibre rifle unless you're shooting bench rest matches.

jpattersonnh 12-27-2011 11:49 PM

Bullet construction... great question. Speer bullets, the old hot core type use a soft lead. If pushed to fast you can get seperation when the bullet expands, not an issue w/ 7.62x54r. Hornady are slightly harder lead and have a ridge it keep the core from slipping, again not an issue for 7.62x54r. Whatever is cheaper. I know the Speer are. As long as accuracy is good you will have no issues including whitetail sized game. Hope this helped. JP

Joshua M. Smith 12-28-2011 01:53 AM

Thanks guys!

I've noticed my Mosin likes whatever has the longest bearing surface and that usually means lead round nose. However, I have several hundred pulled .311 bullets I bought for practice and they all weigh in at 147 to 149 grains, so I'll stick with what I'm zeroed at. I also like speed in my rifles for the shock; I carry a .45 in a handgun only because I can't get the speed for any appreciable shock effect so I want a big hole!

I've not measured the bearing surfaces. I'll have to do that. The Speer looks like it might have the edge there, though. We'll see.

I kinda' thought the Hornady might be more precise because the weight appears to be shifted toward the back some.

I'll just have to get out and shoot when I can cross the creek again.

Didn't figure there was much difference in terminal performance, but the Hornady tip did feel a bit harder.

Was thinking about going with a varmint bullet in 125 grains, but the lead is long on almost any Mosin and I feel I probably need longer bullets.



All times are GMT. The time now is 04:50 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.