Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   General Rifle Discussion (http://www.firearmstalk.com/forums/f18/)
-   -   savage axis trigger job (http://www.firearmstalk.com/forums/f18/savage-axis-trigger-job-52269/)

purehavoc 11-23-2011 02:32 AM

savage axis trigger job
 
before the much needed trigger job pull was just shy of 8# after the trigger rework , spring , polishing and the shims for the side slop it came out on the digital scale at 3.12#. as far as washers for shims the ones I bought were a little to thick and I put them on a sheet of sand paper and sanded them down just enough until it took out the slop and didnt bind , it took less than 5 minutes of sanding and checking to get it to a perfect fit .
Now I need to get out there and get some rounds ran through this thing , its just been way to windy and rainy here to get it done but with a 4 day weekend things are starting to look good


All times are GMT. The time now is 06:22 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.