You are Unregistered, please register to use all of the features of!    
Firearm & Gun Forum - > Long Guns > General Rifle Discussion >

remington 700 replacement safety info and install

LinkBack Thread Tools Display Modes
Old 08-17-2011, 09:06 AM   #11
Feedback Score: 0 reviews
Join Date: Jul 2008
Posts: 249
Liked 53 Times on 39 Posts
Likes Given: 1


So this has raised its head again.
Letís take a look at some of the objections:

"Itís an anti-gun conspiracy / CNBC is biased."

Yes, CNBC is biased, and their story contains slanted perspectives and misleading information. What did you expect? However, just because the presentation is biased doesnít necessarily mean that the core issue isnít true.

"It must be caused by people fiddling with their trigger adjustments."

No doubt some of the problems are indeed due to improper adjustments. However there are lots of rifles that have adjustable triggers that donít have anywhere near as many complaints. Something else is going on.

So let's take a look at what it is:

Here's the Remington 700 trigger cocked:

remington 700 replacement safety info and install - General Rifle Discussion

The Remington 700 trigger is a bit unusual in that it uses an extra piece, the trigger connector, to refine the trigger pull. The tiny red area is the engagement between the connector and the sear.

When the trigger is pulled, the connector goes forward and returns to this position:

remington 700 replacement safety info and install - General Rifle Discussion
For this trigger to operate safely it is essential that when the rifle is cocked the trigger connector return 100% to the proper position, pushed there by only the light weight trigger spring.

See the red area between the trigger shoe and the trigger connector when the rifle is uncocked? That's the problem area. Any tiny speck of dirt, rust, ice or other material that gets in there will prevent the connector from engaging the sear properly. This can result in the safety keeping the sear from falling instead of the trigger connector. When the safety is released, the gun fires.

With all this in mind, let's take a look at a couple more objections:

ďIíve owned a Remington 700 for forty years and fired thousands of rounds and never had a problem.Ē

Good for you. This problem doesnít happen very often, simply because itís fairly difficult for stuff to work its way into the proper area of the trigger. But this is not a question of a few defective guns; itís a design weakness that could affect any of the millions of guns with this trigger. If you havenít had a problem, itís because nothing has worked its way into your trigger.


"This only happens on dirty or neglected guns."

This is more likely to happen on a dirty or neglected gun. However, a grass seed or a bit of pine needle could make this happen on an otherwise pristine gun.

"There wouldn't be any problem if they followed The Rules of Gun Safety."

True enough. You should always treat your gun as though it could go off at any moment. That doesn't excuse making a rifle that actually does it.


So if you want to eliminate the problem from your friend's rifle, replace the entire Walker trigger with a Rifle Basix / Timney / Dayton Traister trigger.
natman is offline  
Reply With Quote

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Firearms Forum Replies Last Post
Remington Model 721 Stock Replacement zukidude General Rifle Discussion 10 09-19-2010 02:17 AM
Remington 870 Safety Key matthew24 General Shotgun Discussion 2 06-09-2009 11:02 PM
Remington 870 Safety Key canebrake The Club House 0 06-07-2009 02:46 AM
Replacement Barrel for Remington 870. mdw104 General Shotgun Discussion 1 03-24-2009 02:24 AM
.28- Remington Info? gottabe1911 Glock Forum 0 05-24-2007 04:47 PM