Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Revolver Handguns (http://www.firearmstalk.com/forums/f16/)
-   -   Revolver strip down! (http://www.firearmstalk.com/forums/f16/revolver-strip-down-29980/)

Vipersnipe 08-02-2010 10:12 PM

Revolver strip down!
 
I need help, I recently acquired a new cylinder hand for my single action heritage rough rider since my old cylinder hand spring broke but I need help taking apart my revolver. I have never taken apart a single action revolver before so specific instructions would be really awesome. :)

danf_fl 08-02-2010 10:42 PM

There are two series of "hands" for the Rough Rider. When my spring broke, I had to get the new style hand and reshape it to work in my older model. The spring itself is not an easy thing to replace.

amoroque 08-02-2010 11:19 PM

2 Attachment(s)
Hope this helps.

IGETEVEN 08-02-2010 11:29 PM

Howdy, try these two websites. One is a owner's manual/diagram and the other is the KTOG forum and some of the posts explain similar replace and disassemble.

http://heritagemfg.com/site/pdf/sbManual.pdf

KTOG Forum - Heritage Rough Rider repair help please

danf_fl 08-03-2010 01:11 AM

Getting back to my post above. We are talking about part "5.1" and not "3.3". If so, that part comes with the spring installed. There is a cut-off on the serial #'s when you go to the Heritage website and try to order the part. The older style is no longer available.

M14sRock 08-03-2010 01:34 AM

I see we are all tip-toe-ing around it so I'll go first.

Welcome aboard! When you have time swing over to the Introductions and tell us about yourself. We are a curious, friendly bunch at FTF.

danf_fl 08-03-2010 02:06 AM

Quote:

Originally Posted by M14sRock (Post 324969)
I see we are all tip-toe-ing around it so I'll go first.

Welcome aboard! When you have time swing over to the Introductions and tell us about yourself. We are a curious, friendly bunch at FTF.

I missed that! Thanks Rock.:)

M14sRock 08-03-2010 03:28 AM

Quote:

Originally Posted by danf_fl (Post 325002)
I missed that! Thanks Rock.:)

Just doing my part to "represent", Dan.

Vipersnipe 08-03-2010 05:30 AM

Thanks!
 
Thanks to all! I have now successfully stripped down and put back together my revolver! I pretty much used all of the information you guys gave me and now it works like it just came out of the box!

Vipersnipe 08-03-2010 05:31 AM

Oh and I'll be sure to go to that introduction section too :D


All times are GMT. The time now is 04:58 PM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.