Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Revolver Handguns (http://www.firearmstalk.com/forums/f16/)
-   -   Another H&R question (http://www.firearmstalk.com/forums/f16/another-h-r-question-3656/)

fapprez 03-10-2008 09:45 PM

Another H&R question
 
So my first problem was cured and I've ordered the parts to replace the damaged ones. Now it says 22LR on the barrel. I have tried 22lr AND 22 shorts and for the life of me I cannot get the round into the cylinder. The head, copper or lead, seems to bind and scrape the sides when I try to insert the cartridge. Now I believe that the guns were first made in '41 and this one is stamped 66xxx as the serial number, so I imagine it was produced somewhere in the 40s. Have the size of the rounds changed since this gun was produced?

Zappa 03-10-2008 11:19 PM

I have a top-break, single-action, 9-shot H&R Sportsman 199 that works very slick, with no sticking and easy ejection. I did get some el-cheapo ammo once that had a heavy waxy type residue on it that made chambering tough, but this was the exception and not the norm. Good old Remmy's, Winny's, Federals and CCI's always worked well.
The dimensions of the .22LR were standardized a long time ago. A .22LR from the 40's is the same size as today. If anything, the chambers were probably a bit looser in the old days than they are today.
When was the last time yours was fired?
Is there any surface rust or crud built up in the chambers?
Are all the chambers just as tight, or just a few?
I'd give it a good cleaning with a few wet patches, then a stiff spiral wound bronze wire brush, and then a few dry patches and see if this makes a difference.


All times are GMT. The time now is 10:31 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.