Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   Semi-Auto Handguns (http://www.firearmstalk.com/forums/f15/)
-   -   Ruger 22/44 mark II extractor issues (http://www.firearmstalk.com/forums/f15/ruger-22-44-mark-ii-extractor-issues-40687/)

ktmboyz 04-02-2011 03:54 PM

Ruger 22/45 mark II extractor issues
 
I have a ruger mark II 22/45 that has been getting worse extracting the spent casings. I have probably only put 500 rounds through it. After stripping and thorough cleaning in the new ultra sonic cleaner, I found the extractor isnt as sharp as it should be and the cavity in the barrel where the extractor goes has a small burr on the ramp.

I ordered a Volquartsen Exact Edge Extractor and was wondering if anyone has good or bad experience with them ?? I love the pistol but really hate having to pluck shells from the chamber all the time :mad:

NGIB 04-02-2011 04:05 PM

Quote:

Originally Posted by ktmboyz (Post 477792)
I have a ruger mark II 22/45 that has been getting worse extracting the spent casings. I have probably only put 500 rounds through it. After stripping and thorough cleaning in the new ultra sonic cleaner, I found the extractor isnt as sharp as it should be and the cavity in the barrel where the extractor goes has a small burr on the ramp.

I ordered a Volquartsen Exact Edge Extractor and was wondering if anyone has good or bad experience with them ?? I love the pistol but really hate having to pluck shells from the chamber all the time :mad:

The VQ extractors are good stuff as is their trigger components...

ktmboyz 04-02-2011 04:27 PM

Thanks,, I can't wait to get it and put it in ! Seems like a cheap fix for 12 bucks

stalkingbear 04-02-2011 04:50 PM

The Exact Edge extractor is a good product and easy to put in. Be careful you don't have the plunger flying across the room however.

ktmboyz 04-08-2011 12:49 AM

Thanks for the replys guys,, I put my new one in today and took it out for a quick 150 rounds adn not one failure to extract. .did have a couple feed issues, the bolt would close on a round half in and bend it. Now to look into that..


All times are GMT. The time now is 10:38 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.