Firearm & Gun Forum - FireArmsTalk.com

Firearm & Gun Forum - FireArmsTalk.com (http://www.firearmstalk.com/forums/)
-   General Handgun Discussion (http://www.firearmstalk.com/forums/f14/)
-   -   Kahr cm 9 mod (http://www.firearmstalk.com/forums/f14/kahr-cm-9-mod-87048/)

glockcj 03-21-2013 01:13 AM

Kahr cm 9 mod
 
I have put a total of 500rnds though it and cleaned it. I noticed shavings on the ploy rail and looked at the top slide that is SS. I was wondering if I should file the SS slide it has a sharp edge. Do you think it is a good idea or should I wait to see if poly stops wearing. Advise

hardluk1 03-21-2013 03:41 PM

Clean it up? Yes but should be done wearing by now . The plastic rails"assembly" rails that is will stop wearing and if you wish to make them look nice take some sandpaper after them or just scrap any plastic edges flat with a pocket knife. I do with any pistol soften any sharp edges and did so with my kahrs but not really needed. Go over talk kahrtalk and intro your self and do some searchs before asking questions. Most results have been covered thru the years.


All times are GMT. The time now is 09:42 AM.

Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.