[Romad54]

My wife has a Mark II Ruger .22 semi auto. We shot it this weekend while camping, so I took it apart (following manual directions) and when attempting to reassemble it the bolt is locked! It wont pull back fully. I was thinking maybe I charged it somehow, or the safety was partially on so took it apart again, and now the locking pin will not seat fully.
Any help would be greatly appreciated!

[winds-of-change]

Been there, done that.

I hope these links will help. You have to tilt the gun and pull the trigger at certain points to get the hammer in the proper position. You are sooo close.


http://www.1bad69.com/ruger/internals.htm

http://www.firearmstalk.com/forums/f33/yes-i-am-now-one-those-45994/

[hiwall]

There is a bunch of how-to videos on u-tube that can help you

[elmerfudge]

We've all done it. Just wait until you take apart the trigger, sear assembly.

[Romad54]

Thank you all!! Watching the videos helped, and I figured out my mistake was SO obvious and stupid!! At least now I know, and wont make the same mistake!!! Again, thanks!!!